Close (stair) walls

Thinner and built on lighter foundations than external walls, close (stair) walls may settle or the foundations be washed away by leaking pipes leading to subsidence and separation cracks.  

The walls that support the stairs are normally single brick walls (called "half brick"). With plaster, this results in a wall about 6" (150 mm) thick. The plaster on both sides of these walls contributes to their strength so "boss" or hollow sounds when you tap walls indicates that plaster has come away from the wall and should be fixed.

Take any structural symptoms (particularly bulges) seriously.

Close painting

Internal painterwork can last for ten years depending on the use and cleaning of the close.

A breathable emulsion paint is best used on the upper wall and ceiling plasterwork. If there are signs of flaking paint or blisters then the surface may need to be scraped back and sealed before being repainted.

The Dado

This is the bottom half of the close wall.  It is normally made of a hard mortar and gloss painted or tiled. 

dado tiles crop lite.jpg
Victorian Dado TilesJohn GilbertNote gloss paint band above tiles to prevent cleaning damage to wall

If you have the original Victorian close tiles, then it is best to try to conserve them. Tiling which is boss (hollow when tapped) may be ready to fall off. This may be the result of moisture from the ground or use of the wrong cleaning agents. Where new tiles fall off the wall, this may be because the wrong render or wrong adhesive has been used.

Cracked and loose tiles can be taken out and replaced although finding matching tiles can be tricky. If your building is listed, approach a ceramic conservator.  Replacing the odd tile with a non matching tile may be a better solution than replacing all the tiles. Gypsum plaster should not be used behind close wall tiles as it can hold moisture.

Wall tiles should be cleaned with soap and water, nothing more. If painted over it may be necessary to use a water based paint stripper or simply remove the paint by using a sharp scalpel blade.

Close walls are plastered "on the hard" (plastered directly onto the brick).  This means that the plaster may crack at wall junctions with external stone walls that tend to have lathe and plaster finish. 

Dampness caused by lack of a DPC in these walls can lead to tiles or plaster becoming detached at ground level.

Separation cracks may occur where the external wall settles more than the internal close walls, although sometimes it is simply caused by thermal movement between different wall finishes.

separation crack crop lite.jpg
Separation crackJohn GilbertClear evidence of movement where the outer wall has settled more than the inner close wall

Professional help recommended?

Although the work may appear straightforward, ensure your builder or tradespeople have the skills for the job. If in any doubt, get professional help to specify and organise the repair.

Who pays?

These are normally common or mutual repairs. There may be particular issues with main door flats and shops.